伸缩门"机器人"刚走一会又退回去的原因?
Why did the telescopic door "robot" just leave and then retreat back?
1、没有埋设"机器人"所的磁铁线路,请按照产品说明书要求安装'
1. The magnet circuit for the "robot" station is not buried. Please install it according to the product manual requirements
2、磁铁的极性不统一,安装不正确,请将磁铁的磁性统一一个极性安装!
2. The polarity of the magnet is not uniform, and the installation is incorrect. Please install the magnet with the same polarity!
3、探测器安装反或者已损坏,请将探测器互换一下,情况还是如此,请更换探测器!
3. The detector is installed incorrectly or damaged. Please exchange the detector, but the situation is still the same. Please replace the detector!
三.伸缩门按遥控器时,该门无反应,如何处理
3、 When pressing the remote control for the telescopic door, the door does not respond. How to handle it
1、检查是否对控制系统线路板通电,若无,请通电'
1. Check if the control system circuit board is powered on. If not, please power on
2、门排后面接线盒正负极是否接反安装正确,若反,请将其纠正;
2. Check if the positive and negative poles of the junction box behind the door truss are correctly connected in reverse. If so, please correct them;
3、检查遥控器背面标签所示遥控编码与遥控接收模块背面标签所示的遥控编码是否一致,若不一致,需查找统一的编码或请专业维修人员编码,也致电我司专业人员;
3. Check if the remote control code shown on the label on the back of the remote control is consistent with the remote control code shown on the label on the back of the remote control receiver module. If there is any inconsistency, you need to search for a unified code or ask a professional maintenance personnel to code, or call our company's professional personnel;
4、电源指示灯是否正常亮,若不亮请更换电池,若还是一样!请更换新遥控器
4. Is the power indicator light on normally? If not, please replace the battery. If it still remains the same! Please replace the remote control with a new one